1.classify the small and middle sinter ore whose temperature is about 600-800centigrade.
2.exported to America, Europe, Africa
WSAR hot mine vibrating screen:
WSZR series hot mine vibrating screen are widely used in metallurgy industry to accomplish the classification of the small and middle sinter ore whose temperature is about 600-800°c and finish equably feeding material to the cooling equipment.
Basing on the working situation, the motor can be installed in the left side or right side. According to the install locations of the motor and exciting machine, vibrating screen can be divided the upper vibrating and bottom vibrating types. We can design and manufacture different types of vibrating screen according to customer requirements.
Installation and test
a. Check the concrete foundation, bolts and steer plate according to installation chart before installation. The allowable error is within3mm.
b. The series must install on sequence from the bottom to the up, every steps must be adjusted to the primary status before the install of nest steps.
c. Should adjust the mesh to the appropriate place after vibrating screen installation. Both first and second damping spring should keep vertical status. The axes of the vibrating motor should be lower 3-5mm than that of exciting machine. Weld the motor bracket ,spring seat and steel plate.
d. Make sure the spinning directions of two vibrating motors are reverse.
e. The screen can run for 4-6hours under no-load state inquiring the operating balance of the screen body, without swing and un-normal sound. Check the fastness of the screen boards and exciter machine.